Answer / sagar.tinkhede

The standard Height for Control Panel is 2200(H)X 1000(W)X
800(D).

Answer / binu

The standard Height for Control Panel is 2200(H)X 800(W)X
800(D).

Answer / chandrasekaran.n

THE STANDARD DCS SYSTEM & MARSHALLING CABINET HIGHT 2120MM

My question may be very basic or childish but this question still persists in me, someone plz help me 1.why do we go for differential equations to analyze a system? 2.why do we solve it using matrices, is there any specific reason for using matrices other than the stories like it is simple,faster etc.

2 Answers  

---

what is absolute pressure, gauge pressure and atmospheric pressure?

2 Answers   Mother Dairy,

---

i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....

0 Answers  

---

What are the Components of Siemens S7 300 Series PLC system ?

1 Answers   Siemens,

---

What are different types of orifice plates?

0 Answers  

---

What is close loop ?

1 Answers   College School Exams Tests, GMR,

---

Where can i take training in intools software for Instrumentation design??

9 Answers  

---

why we are using boosters at glass furnace is there any other thing?

1 Answers   CGL,

---

what is SIL 1 2 3

0 Answers   KOC,

---

what deference between panel earth and systemearth

0 Answers   Tecnimont,

---

In control valve , Failure position : Close If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..

2 Answers  

---

What is the difference between DCS and SCADA?

1 Answers  

---