Answer / lalit joshi

pt pumps answer you can find in any cummins dg sets
manual.It is pressure timing pump.The main purpose is to
ensure the fuel delivery in variable quantity as per the
load requirements of the DG set.

Answer / saurabh chauhan

Pressure timming pump sucks the fuel from the fuel tank
through filters and water separator. After that it delivers
the fuel to a common rail from where the fuel goes into the
injectors.

The pump also governs the speed of the engine by
controlling the throttle shaft position which in turn
controls the amount of fuel going into the injectors.

Answer / nagarjuna reddy

PT Pump in the sense which withdrawas the diesel through filters and water seperators.from fuel tank. It is very helpful that if any air enters into the fuel system which may not drop the engine speed which is specially observed in Cummins Generators only.
And also it will gives maximum pressure which is very helpful to good fuel automization...

Answer / phani

u r simply telling 'pt'.
write the full form.
then only anyone can understand ur question

my jindal interview is on 24th.. can anyone give me few tips regarding the same? lik how i shud prep

0 Answers  

---

• Have you previously successful in this position progressed to within the company you have worked with?

1 Answers   Petro Star Mount,

---

what is continuous-emission monitoring(CEM)System?

1 Answers  

---

Explain how to clean LO

0 Answers  

---

I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????

7 Answers  

---

What device installed in the F.O. system when excess oil return to drain tank?

0 Answers  

---

which mechanism is used to turn the vehicles?

20 Answers   Hyundai, NTPC, TCS,

---

Give five reasons why a reciprocating pump will reduce capacity or pressure when delivering water

0 Answers  

---

Is there a metal that does not contain iron?

0 Answers  

---

Why Slag comes on top of weld bead & if ur answer is related to density then think of overhead welding if slag is ligter than weld metal then in overhead welding firstly a laye of slag & then a layer of weld metal must be deposited.

3 Answers   SGS,

---

hai friends please send me the previous question ntpc questions both tecnical and apptitude papers for my mail. and also post me the areas in which u have faced difficulties that might help ful to me. so please send the answer to my question. my mail id is sweety4834u@gmail.com

0 Answers  

---

In what principal an hydraulic governor does work?

2 Answers  

---