Answer / ankit

cavitation depends upon the phenomenon of the boiling of
the liquid.
BOILING OCCURS WHEN THE VAPOR PRESSURE OF THE LIQUID IS
GREATER THAN ATM.(LOCAL) PRESSURE. THE SAME THING IS SAME
IN THE CASE OF CAVITATION.
CAVITATION CONSIDER THE MAIN FATOR IN THE PUMP.
WHEN THE LIQUID VAPOR PRESSURE IS GREATER THAN THE ATM.
PRESSURE THEN BUBBLE FORMATION OCCURS AND THIS CAUSES THE
PROBLEM FOR THE PUMP'S OTHER PARAMETERS LIKE CAPACITY,
POWER, HEAD, ETC. THE MAIN POINT OF CONCERN IS THAT THIS
CAUSES PROBLEM FOR THE IMPELLER AND ITS SPEED
FOR PREVENTION FOR THIS PHENOMENON TWO FACTOR ARE: ONE IS
TEMPERATURE CONTROL AND REQUIRED NPSH. LAST ONE IS ON THE
MAIN FOCUS.
FOR THE PREVENTION OF THE CAVITATION WE SHOULD BE CONFIRM
THAT OUR REQUIRED NPSH IS SUITABLE FOR THE PUMP AND PUMP
STATIC HEAD.

Answer / abdul rahman

Cavitation obviously occured due to the lack of demanded
volume of water inside the pump chamber causing vacuume
pressure developes than the water pressure resulting
bubbles hammering to the pump walls leading to the failure
of the pump






Is This Answer Correct ? Yes / No

Answer / yaregal alefe

CAVITATION-is the process of the formation and subsequent collapse of vapor bubbles in a pump, is called CAVITATION.
CAVITATION is a series damage of the impeller.that is it in short definition.

why the rail in form of I-beam?

1 Answers  

---

How you find the bearing outer diameter, bearing thickness using bearing number? What is the formula?

1 Answers   Unilever,

---

In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?

0 Answers  

---

My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.

0 Answers  

---

What is absolute pressure

3 Answers   RRB,

---

project,planning, equioment erraction &maint format. project,planning&scheduling,bar chart

0 Answers  

---

Explain the terms solid solution, eutectic, eutectoid and peritectic.

0 Answers  

---

Tell me on steel

0 Answers   Tata Steel Limited,

---

What do you mean by cotter joint?

0 Answers  

---

what is the termodynamic?

5 Answers  

---

What is equivalent spring constant for spring in parallel?

3 Answers   Bhel,

---

Poisons ratio is higher in (rubber/steel/wood)

5 Answers   Essar,

---