how will you check torque value during Factory acceptance Test for control valve

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

Question Posted / sethuraman

0 Answers
2494 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Instrumentation Interview Questions

what is the T/C & RTD mesuremaint?

3 Answers

what's the minimum level required of SIL (safety integrity level)to use fire and gas system?

2 Answers L&T,

can install leveltrol in steam drum for measurment the level of steam drum? if not then why?

1 Answers

What are the two program execution modes of PLC?

4 Answers

WHAT DO WE MEANT BY INSTRUMENT MAINTENANCE IN SOFTWARE SIDE.

1 Answers

ORP sensor working principle?

0 Answers Tata Steel Limited,

Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.

0 Answers

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

1 Answers Indian Steel,

tion 0,50,100% equql to voltage formula?

1 Answers

Why flow/pressure transmitter before control valve?

0 Answers UPL,

Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?

0 Answers

what is ILD

1 Answers

For more Instrumentation Interview Questions Click Here