How we can see mac address from dos prompt?

0 Answers  

---

Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation

2 Answers  

---

What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot

2 Answers  

---

Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2

3 Answers  

---

What is the command to allow you to type Tokyo instead of the IP address 172.16.30.1 to access a router named Tokyo? A.) config t, ip host Tokyo 172.16.30.1 B.) config t, ip hostname Tokyo 172.16.30.1 C.) config t, hostname Tokyo 172.16.30.1 D.) config t, ip hostname 172.16.30.1 Tokyo

1 Answers  

---

Which statement about the data link connection identifier (DLCI) is true? A. It is a number that identifies a local virtual circuit in a Frame Relay network B. It is a signaling standard between the CIDE device and the Frame Relay switch C. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay Cloud D. It is the Maximum number of uncommitted bits that the Frame Relay switch will attempt to transfer beyond the Committed Information Rate (CIP)

2 Answers  

---

'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

---

On which base switches take decisions?

0 Answers  

---

Bridges work at what layer of the OSI model? A.) Data Link B.) Network C.) Physical D.) Application

12 Answers   KVS, PGT,

---

Identify the 2 types of access-list filters that control SAP traffic? A.) Novell-ether B.) Arpa C.) Input-sap-filter D.) Round-robin E.) Output-sap-filter

1 Answers  

---

What is the difference between switch and hub?

0 Answers  

---

what is used for passive intercae comand mine answer-to prevent to take update from outside

2 Answers  

---