1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

LAN stands for which of the following?

A.) Local Area Network

B.) Local Arena Network

C.) Local Area News

D.) Logical Area Network

Question Posted / guest

Answers were Sorted based on User's Feedback



LAN stands for which of the following? A.) Local Area Network B.) Local Arena Network C.) L..

Answer / guest

Answer: A

LAN stands for Local Area Network

Is This Answer Correct ?    6 Yes 0 No

LAN stands for which of the following? A.) Local Area Network B.) Local Arena Network C.) L..

Answer / rjt

answer is "A". Local Area Network

Is This Answer Correct ?    2 Yes 0 No

LAN stands for which of the following? A.) Local Area Network B.) Local Arena Network C.) L..

Answer / nilesh d

Answer Is 'A' Lan Stands For Local Area Network

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More CCNA Interview Questions

9. Which STP state prevents the use of looped paths? A. Blocking B. Listening C. Learning D. Forwarding

2 Answers  

Your PC has been configured with IP Address 192.168.3.25 and a subnet mask of 255.255.255.0. Which of the following IP Addresses is a valid default gateway address for your PC? 192.168.3.0 255.255.255.0 192.168.3.2 255.255.255.0 192.168.3.25 255.255.255.0 192.168.4.1 255.255.255.255

2 Answers  

Define bandwidth?

0 Answers  

How are straight and crossable cables different from each other?

0 Answers  

Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  




What command do you use to disable domain lookup? A.) no domain-lookup B.) domain no-lookup C.) lookup no-domain D.) no ip domain-lookup

1 Answers   Microsoft,

What is osi reference model?

0 Answers  

In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to NVRAM before becoming enabled

1 Answers  

Explain why is udp lease favored when compared to tcp?

0 Answers  

What do you understand by poe (power over ethernet)?

0 Answers  

Extended IP access-lists (100-199) can be used to control traffic. Which command listed below will permit smtp mail to only host 3.4.5.6 ? A.) It is not possible for SMTP traffic B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23 D.) access-list 102 permit tcp any any eq smtp E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25

1 Answers  

What is the difference between switch, routers, and hub?

0 Answers  

For more CCNA Interview Questions Click Here
Categories