Which of the following are valid WAN terms?
A.) DTE
B.) DCE
C.) Demarc
D.) CPE
Answers were Sorted based on User's Feedback
Define class full protocol?
what is ip address?
What is true when creating static route? A.) The mask parameter is optional B.) The administrative distance is required C.) The gateway parameter is required D.) The administrative distance is optional
2. What are the valid ways to segment a LAN? (Choose all that apply) A. Repeater B. Bridge C. Switch D. Router
I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
What is the terminal emulation?
Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) Show clock rate serial 0 D.) show controllers serial 0 E.) show running-config
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction
IP extended access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) all of the above C.) protocol D.) source address E.) port
How do you depict an IP address?
what is meant by domain ? what is mean by DNS?