What is a key use of a device hardware address? A. to obtain a vendor code / serial number from the user B. to transmit a frame from one Interface to another Interface C. to transmit a packet from one local device to another local device D. to transmit data from one local device to a remote device across the internet E. to contain logical information about the device to use for end-to-end transmission

1 Answers  

---

what is native vlan any one explain sooraj

7 Answers   IBM,

---

Which of the following is used to manage and monitor the network? A.) SNMP B.) HTTP C.) IP D.) FTP

1 Answers  

---

What are the advantages of lan switching?

0 Answers  

---

Identify the 3 methods routers learn paths to destinations? A.) Dynamic routing B.) None of the above, configured by default C.) Default routes D.) Administrative distance E.) Static routes

1 Answers  

---

Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM

1 Answers  

---

Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance

1 Answers  

---

Hi Jitendera, I need ur suggestion. I completed my CCNA certification & also hving some sort of real time experience. Now i m planning to do CCNP. Little bit confusion is that whether it wud be better for me to go for CCNP ya CCNA (Security). As off my goal is to reach CCIE (Security & Switching/Routing). So tell me some solution of my confusion yaar..!!! Thanx & Regards Shahin..

1 Answers  

---

GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong

0 Answers  

---

What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

2 Answers  

---

Explain the difference between half-duplex and full-duplex?

0 Answers  

---

What is the purpose of data link layer?

0 Answers  

---