do we use links in a dc circuit?if so what s its use in it?

0 Answers  

---

As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.

0 Answers  

---

what is the difference between synchronous generator & asynchronous generator

4 Answers   Reliance,

---

The ohm is the unit of:(a) Charge(b) Resistance(c) Power(d) Current

2 Answers  

---

how can we run the induction motor at 9000 rpm ,by keeping frequency constant??

2 Answers  

---

I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.

1 Answers  

---

if a damaged 500kva transformer with %impedance 2.6 is replaced by two transformers of 250Kva with different % impedance will they be able to catter the load. what will be the ratio of load on the two transformers if the % impedance is in the ratio 1:2

2 Answers   Siemens,

---

what happens when ac supply is given to the dc motor and dc supply is given to the ac motor?

1 Answers   GATE,

---

plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in

0 Answers   Bhel,

---

power formula

1 Answers  

---

Meggering minimum acceptable Ohms for insulation resistance.

1 Answers   TATA, Wood Group,

---

at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)

0 Answers   Ebrahim Textile, Siemens,

---