we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers  

---

Mention the disadvantages of low power factor?

0 Answers  

---

circuit breaker work alone during fault condition or need any relays ?

4 Answers  

---

how to find out this one mcb r mccb?

4 Answers   L&T,

---

When do you use a VFD motor?

1 Answers  

---

---

What is difference between safe PLC and normal PLC

0 Answers  

---

What is the lower limit of megger value for 66/11KV power Transformer ?

7 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd, Torrent Power,

---

electric contractor ya contactor kia hota hy ? or kesy connect kia jata hy ?

1 Answers  

---

What is the principle of Excitation.

1 Answers  

---

WHAT SHOULD BE THE RATING OF generator required to run a pump motor of 45 Kw.

1 Answers   Jauss Polymers,

---

what will happen if neutal in AC ckt will get open

3 Answers  

---

What kinds of decision are made about CT from it's Knee point(voltage & current)?

2 Answers  

---