Answer / guest

Answer: F

ICMP is used for error handling and testing at layer 3. Ping and

traceroute are examples of ICMP.

Answer / m haja bahurudeen

Ans : F

ICMP is testing distination IP address

Which two commands show your access lists? (Choose two) A. show filters B. show access-lists C. show ip access-lists D. show running-config

2 Answers  

---

Which layer defines the physical topology? A.) Application B.) Transport C.) Network D.) Data Link E.) Physical F.) Session

1 Answers  

---

Which command displays the IPX SAP table? A.) show ipx sap B.) show sap C.) show ipx interface D.) show ipx servers E.) show ipx

1 Answers  

---

What is STP and what is the difference between PVST and RSTP

0 Answers   Infosys, Wipro,

---

completly describe th steps fo osi model when you enter http:/youtube.com

1 Answers   HCL,

---

---

Write out a config to permit only the below MAC address to pass traffic through a port on your switch. mac-address 0005.1b00.5b58

4 Answers  

---

CSMA/CD stand for which of the following? A.) Carrier Sense, Multiple Access with Collision Detection B.) Collision Sense, Multiple Access with Collision Detection C.) Collision Sense, Multiple Access with Carrier Detection D.) Carrier Sense, MAC address with Collision Detection

1 Answers  

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

2 Answers  

---

Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router

1 Answers  

---

The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.

2 Answers  

---

What is the subnet? Why is it used?

0 Answers  

---

When ospf protocol advertise its routing table?

0 Answers  

---