What is a network subnet?
- 0 Answers
- 650 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
There is a process in Frame-Relay where LMI resolves an IP address from a DLCI number. What is this called? A.) arp B.) inverse arp C.) rarp D.) automap E.) reverse arp F.) arp
You are given the following address: 15.16.193.6/21. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.248.0, A, 15.16.192.0, 15.16.199.255 B. 255.255.248.0, B, 15.16.192.0, 15.16.199.255 C. 255.255.248.0, A, 15.16.199.255, 14.15.192.0 D. 255.255.242.0, A, 15.16.192.0, 15.16.199.255
Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) show clock rate serial 0 D.) show controllers serial 0 E.) show running-config
Explain the difference between collision domain and broadcast domain.
What is the difference between communication and transmission?
What command displays the OSPF section of the running-configuration?
What is the Difference Between Windows 2003 And Windows 2008 Server?
What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.
what is distance vector protocol link state protocol and what is the diffrence between them
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?
I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?
CCNA 
