Explain the difference between flsm and vlsm?
- 0 Answers
- 875 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) show clock rate serial 0 D.) show controllers serial 0 E.) show running-config
how to troubleshoot when protocols is down and link is not getting up
How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Router(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run
What is Standard ACLs?
What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II
You have an IP host address of 201.222.5.121 and a subnet mask of 255.255.255.248. What is the broadcast address? A. 201.222.5.127 B. 201.222.5.120 C. 201.222.5.121 D. 201.222.5.122
GUY i Have attended one interview for the data craft and they are offering me L1 postion and i am working at l2 in cisco so there is no way to get in the datacraft i am posting here the question he asked to and i have tested the interviewer and i come to know he was not having any knowledge. His questions are-: 1) what is Vlan 2) what is stp and what is difference between stp and RSTP 3) what is HSRP and Diffrence betwwen HSRP and GLBP 4) how to configure HSRP 5) Scenario Based question ( if we have two router and both are connected and there are having redundancy means two interface of the router r1 is connected to the two interface of Router R2 (R1)-------------(R2 (R1)-------------(R2 Now he want to configure the router in such a Manner that if one link down second link should come up.My answer was HSRP and his is "F looting static routing was i wrong "i know F looting Static routing is Theoretically possible but it is not fusible in the scenario where you have multiple router connected to the same router and if you have configured sub interface i challenged him and he lost The Battle and he get angary 5) what the eigrp and how it works 6) tables in eigrp 7) the information of feasible successor where it saved now after answering these all he was very angry ( i can fill the heat) 8) then he come to ospf Area type ( he was also not aware) 9) LSA type and its working ( he was also having confusion ) 10) then is asked routing by rummer( Theroy) 11) hello and dead intervel of EIGRp (theory) 12) Selection cretaria for Eigrp slecting best path ( here we have a long discussion on MTU and he lost the battle and agree That MTU never comes in the accounts in this process) 13) what is ACL type of acl ( here he was aware of TWO type Standard and extended i have told him 5 type( he again get Angry) We have 2hr of discussion and and he told me he will call me latter but i know he never call
Which technology is used by Catalyst switches to resolve topology loops and ensure data flows properly through a single network path? A. virtual LANS (VLANS) B. frame filtering C. cut-through switching D. spanning-tree protocol
In Novell's use of RIP, there are two metrics used to make routing decisions. Select the two metrics. A. Ticks. B. Hops C. Loops D. Counts
What are the possible ways of data exchange in ccna?
What is the difference between dynamic NAT and NAT overloading
Port selection is done at which layer of OSI reference model?????
CCNA 
