When using RIP, routing updates are broadcast every ____ seconds. A. 30 B. 10 C. 60 D. 90

4 Answers  

---

Which two statements about a bridge are true? (Choose two) A. A bridge floods multicasts B. A bridge floods broadcasts C. A bridge does not flood multicasts D. A bridge does not flood broadcasts

1 Answers  

---

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

2 Answers  

---

Which of the following encapsulation types can be used on leased-line connections? (Choose two) ❍ A. HDLC ❍ B. Frame Relay ❍ C. ISDN ❍ D. PPP

10 Answers   Wipro,

---

Can you explain encapsulating, carrier and passenger protocol?

0 Answers   CCIE,

---

What does a metric of 16 hops represent when using RIP? A.) Number of hops to the destination B.) Destination unreachable C.) Number of routers D.) Bandwidth

2 Answers   IBM,

---

Hi Gyes, here is new question. can you provide answer of following question Like linux, can we windows as router? If yes how can we able to do this,

2 Answers  

---

What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

1 Answers  

---

How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds

2 Answers  

---

Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  

---

Hi, All I am configuring EIGRP in Packet tracer, after configuring all the things it is not working but in one condition it is working fine if i am putting all my router and network withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but whenever i am puting different network subnets e.g. in one network it is RA(config-if)#=ip address 10.0.0.1, and in fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in third router RC(config-if)#=ip address 11.0.0.2 and in fa 0/0 172.16.1.10 and after configuring all this serial is showing up and protocol showing up but eigrp process not taking place after adding eigrp configuration, i tried with "no auto-summary" command but not working.. Suggest me where i missing something? can mail me at : gtech.innovator@gmail.com

20 Answers  

---

What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward

1 Answers  

---