Answer / shabeeb

the above 4 are correct.
plus SECRET PASSWORD

Answer / jitendera kumar sinha

there are usaly 4 passsowrd
1 pssword for privilage mode
2 line cobsole 0
3 line vty 0 4
4 line aux
so these are the some main password component that can we
implment on the cisco router.
thanks
jitendera kuamr sinha

Answer / s.m.feroz ahmed

Hi,

We can configure 2 passwords on a Router one is hidden
asterix and one is invisible.

Which type of switching reads in the entire frame before forwarding it? A.) Tabling B.) Store-and-Forward C.) Inverse ARP D.) Fast Forward E.) Cut-Through F.) Routing

1 Answers  

---

CPE is an acronym for which of the following? A.) Customer Premise Equipment B.) Central Processing Engineering C.) Customer Process Equipment D.) Central Processing Equipment

2 Answers   Cisco,

---

Which ISDN protocol prefix specifies switching and signalling? A.) I B.) E C.) Q D.) S

1 Answers  

---

if i had a video conferencing device why should it is needed to configure a static IP for that,will it not work on the local lan.

2 Answers   HCL,

---

Identify the mode reflected by the following prompt 'Router'? A.) Setup B.) RXBoot C.) Boot mode D.) Privileged exec mode

2 Answers   Cisco,

---

Explain what are the ranges of private ips?

0 Answers  

---

Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP

7 Answers  

---

What is default time of hello packets in ospf?

0 Answers  

---

Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol

4 Answers  

---

Which command can verify only Network layer connectivity between 2 hosts? A.) ping B.) e-mail C.) plp D.) arp E.) telnet

4 Answers  

---

Hi Guys i hv one confusion. Need u peoples help. In EIGRP, maximum hop count is up to 255. By default only 100. Now question is - a) Suppose i hv a network consist of 115 routers & EIGRP routing protocol is configured. By default hop count is 100, so is there any manual configuration necessary for hop count ya router will automatically detect the hop count & will update the hop count accordingly..????? b) In EIGRP, Bandwidth & Delay is used to calculate metric. For this Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0 Now i want, Bandwidth & Load is used to calculate metric. For that wat i hv to configure & wat wub the metric weights. Cud anyone explain it plzzzz..!!!!

5 Answers  

---

Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  

---