Which statement about an IP network is true? A. A broadcast source MAC address contains all zeros B. A MAC address is part of the physical layer of the OSI model C. MAC addresses are used by bridges to make forwarding decisions. IP address are used by routers. D. IP addresses allow a flat addressing scheme. MAC addresses use a hierarchical addressing scheme.

2 Answers  

---

Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?

0 Answers   Wipro,

---

'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

---

You need to come up with a TCP/IP addressing scheme for your company. How many network IDs must you allow for when you define the subnet mask for the network? A.) One for each WAN link B.) One for each router interface C.) One for each NIC installed in each client D.) One for each subnet with hosts E.) One for each host ID

1 Answers  

---

Explain the difference between baseband and broadband transmission in ccna?

0 Answers  

---

---

Which of the following is an example of the Network Layer? A.) LLC B.) SQL C.) Token Ring D.) IPX E.) SPX

1 Answers  

---

What is the difference among straight cable, cross cable and rollover cable?

0 Answers  

---

Which of the following is an example of the Network Layer? A.) Token Ring B.) RARP C.) LLC D.) DDP E.) TCP

1 Answers  

---

Which feature should a routing protocol have to support vlsm?

0 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

4 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make fowarding decision using MAC address E.) Create collision domains

1 Answers  

---

What is point-to-point protocol in ccna?

0 Answers  

---