Does switch has the IP Address. If YES? How to find it?

7 Answers   Wipro,

---

What is Transport and Tunnel mode?

0 Answers   CCIE,

---

Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction

1 Answers  

---

When using RIP, routing updates are broadcast every ____ seconds. A. 30 B. 10 C. 60 D. 90

4 Answers  

---

Which IP Address Class can have 64,000 subnets with 64,000 hosts per subnet? A. Class B B. Class A C. Class C D. Class D

2 Answers  

---

Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it

2 Answers  

---

You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.

2 Answers  

---

Why Authentication Header (AH) is not compatible with the network that using NAT?????? Jitu, looking for u specially...!!!! U knw why i m looking for u..!!!

1 Answers  

---

The Cisco Discovery Protocol (CDP) periodically sends out a multicast packet (at layer 2). Which command will alter the default interval of 60 seconds? A.) cdp hold 111 B.) cdp wait 111 C.) cdp interval 111 D.) cdp 111 E.) cdp timer 111

1 Answers  

---

The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC

2 Answers  

---

What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward

1 Answers  

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---