Identify the switching method that examines the destination MAC

address as

the frame is being received then begins forwarding the frame
prior to

receiving the entire frame?

A.) Fragment-free

B.) Store and Forward

C.) Cut-through

D.) Fast forward

Answers were Sorted based on User's Feedback



Identify the switching method that examines the destination MAC address as the frame is being ..

Answer / guest

Answer: C

Is This Answer Correct ?    2 Yes 0 No

Identify the switching method that examines the destination MAC address as the frame is being ..

Answer / girirajan

B.) Store and Forward

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More CCNA Interview Questions

ccna syallabus and what is the mean by troubble shooting

2 Answers   IBM,


What is ping utility?

0 Answers  


What is the igp (interior gateway protocol)?

0 Answers  


Can you explain PPTP (Point-to-Point Tunneling Protocol)?

1 Answers   CCIE,


In eigrp metric parameters which 2 options are enable by default?

0 Answers  






Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

2 Answers  


Whith the hierarchical numbering of IP addressing what determines the spoon of the address that will identify the network number? A. subnet mask B. dots between octets C. class of the first octet D. assignments of DHCP E. address resolution process

1 Answers  


Which command can verify only Network layer connectivity between 2 hosts? A.) ping B.) e-mail C.) plp D.) arp E.) telnet

4 Answers  


What is the syntax to add a banner to the Cisco router? A.) motd banner # B.) banner C.) banner motd # D.) banner #

2 Answers  


Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, that network is advertised with an infinite metric

1 Answers  


A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?

2 Answers   Satyam,


For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  


Categories