Tell us the name of algorithm of eigrp protocol?

0 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

1 Answers  

---

Which IP host address range is allowable given an IP address of 172.37.2.56 and 12 bits of subnetting A. 172.37.2.48 to 172.37.2.63 B. 172.37.2.48 to 172.37.2.62 C. 172.37.2.49 to 172.37.2.62 D. 172.37.2.49 to 172.37.2.63 E. 172.37.2.55 to 172.37.2.126

1 Answers  

---

Name a major component of the Point-to-Point Protocol (PPP) to negotiate and set up control options on the WAN data link. A.) RFC 1661 B.) High Level Datalink Protocol (HDLC) C.) Challenge Handshake Authentication Protocol (CHAP) D.) SS7 E.) Link Control Protocol (LCP)

2 Answers  

---

What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC

2 Answers  

---

How much hold down time of eigrep protocol?

0 Answers  

---

Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252

1 Answers  

---

What is the main advantage of using switches?

0 Answers  

---

What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category

3 Answers  

---

Which can be logged by IPX extended access lists? A.) source address B.) protocol C.) source socket D.) access list number E.) destination socket F.) destination address

1 Answers  

---

What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count

2 Answers  

---

What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.

2 Answers  

---