Interested to Buy Any Domain ? << Click Here >> for more details...
Which IP host address range is allowable given an IP address
of 172.37.2.56 and 12 bits of subnetting
A. 172.37.2.48 to 172.37.2.63
B. 172.37.2.48 to 172.37.2.62
C. 172.37.2.49 to 172.37.2.62
D. 172.37.2.49 to 172.37.2.63
E. 172.37.2.55 to 172.37.2.126
- 1 Answers
- 6957 Views
- I also Faced
- E-Mail Answers
If there is only 2 host in bus topology is that possible collision accord?
which layer is responsible for flow control with sliding windows and reliability with sequence number and acknowledgement? A)Transport. B)Application C) Internet D)Network Interface
Which defined peer ip address an local subnet belong to crete?
When we use extended access-list?
Which type of Ethernet framing is used for TCP/IP and AppleTalk? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable
Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory
How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain
Explain what are the ranges of private ips?
You want a message to be displayed every time someone tries to log on to the router. Which command is required to accomplish this task? A.) motd#(message)# B.) banner motd(message) C.) banner motd#(message)# D.) banner motd*(message) E.) banner login#(message)#
Which show command should you use to view Frame Relay Local Management Interface (LMI) Frame statistics? A. show lmi B. show ip route C. show interface D. show statistics E. show frame-relay lmi
Brielfly explain the conversion steps in data encapsulation
CCNA 
