Interested to Buy Any Domain ? << Click Here >> for more details...
Given the following IP address from the Class C address
range 192.168.21.12. Your network plan needs addresses for
28 small prkps Each office uses its own shored. The
network design specifies that you confound for five bits of
subnetting. When you confound for this in Cisco IOS
software which shored mask should you use?
A. 255.255.0.28
B. 255.255.255.0
C. 255.255.255.28
D. 255.255.255.248
E. 255.255.255.252
- 1 Answers
- 6642 Views
- I also Faced
- E-Mail Answers
Identify 2 characteristics of PPP? A.) Uses LLC to establish the link B.) Default serial encapsulation C.) Support multiple layer 3 protocols D.) Offers two types of authentication; PAP and CHAP
What is the most common layer 2 device? A. Hub B. Router C. Switch D. Repeater
Which OSI layer handles physical addresses and network topology? A.) Presentation B.) Physical C.) Transport D.) Application E.) Data-Link F.) Network
What does the Spanning Tree Algorithm (STA) do? A.) Restore lost frames B.) Builds routing tables for routing through an internetwork C.) Forward packets through a switch D.) STA is implemented by STP to prevent loops
What is a backoff on an 802.3 networks A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. it is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged.
Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip
What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II
Which command specifies a second subinterface on serial interface 0? A. interface s 0.2 point-to-point B. interface 2 s.0 point-to-point C. suberinterface 2.s 0 point-to-point D. interface s 0 sub 2 point-to-point E. interface s 0.1 point-to-point sub 2
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
What is default cost of serial interface in ospf?
Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp
Identify 2 functions of IPX access-lists? A.) Control SAP traffic B.) Limit number of Novell servers on a network C.) Limit number of workstations on a network D.) Block IPX traffic
CCNA 
