Answer / guest

Answer: D

what is the purpose of multicast packets?

2 Answers  

---

. Which command sequence will allow only traffic from network 185.64.0.0 to enter interface s0? A. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-list 25 out B. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-group 25 out C. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-list 25 in D. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-group 25 in

1 Answers  

---

The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.

2 Answers  

---

Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco

1 Answers  

---

hi shain can u send me some detail about bgp so that i can enhance my knowledge over bgp and can you also teach me about the process of suppernating. now what i am thinking that this could be last visit on that site overhere.so please mail that short of thing on my gmail id i am requesting to all of the visitor that please send theire doubt or question to my new gmail id which is jitendera.ccnainterview@gmail.com.i will try to solve it if i am capable to do it Wishing all of you for great future Jitendera kaumar sinha

0 Answers   HCL,

---

What are characteristics of UDP A. It is reliable and acknowledged B. It is unreliable and acknowledged C. It is reliable and unacknowledged D. It is unreliable and unacknowledged

2 Answers  

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

1 Answers  

---

Which 3 statements describe default encapsulation and LMI type configuration? A.) There are only four encapsulations and 3 LMI type options B.) The LMI type config term options C.) In release 11.3 the LMI type is autosensed D.) The default LMI is Cisco E.) IETF encap must be configured unless the connecting routers are both cisco

1 Answers  

---

Identify the command to configure the router to boot from an IOS located on a TFTP server? A.) boot system tftp IOS.exe 172.16.5.1 B.) boot system tftp 172.16.5.1 IOS.exe C.) boot system flash tftp 172.16.5.1 D.) boot system IOS.exe 172.16.5.1

1 Answers  

---

Which of the follwing are true of standard half-duplex Ethernet circuitry? A. It is alternate one-way communication B. The receive (RX) is wired directly to the transmit (TX) of the remote station C. The transmit (TX) is wired directly to the receive (RX) of the remote station D. Collisions are not possible E. Both stations can transmit simultaneously

2 Answers  

---

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

1 Answers  

---

Which frame has a Type field to identify the upper-layer protocol? A.) 802.3 B.) 802.2 C.) 802.5 D.) Ethernet_II

2 Answers  

---