What do you use the Aux port for?
A.) Console
B.) Terminal editing
C.) Modem
D.) Backup logging
- 3 Answers
- 10027 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / rahul
C.) Aux port is used to get the remote access of the router
with a modem.
| Is This Answer Correct ? | 26 Yes | 3 No |
Answer / guest
Answer: C
The auxiliary port is used to connect a modem to for dial
backups.
| Is This Answer Correct ? | 17 Yes | 2 No |
How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three
Although Cisco IOS 11.2 and later can auto-detect the LMI type in Frame Relay, which command will force the LMI type to q933a? A.) frame-relay lmi-type q933a B.) encapsulation frame-relay q933a C.) don't need to, it is the default D.) encapsulation q933a E.) encapsulation frame-relay type=q933a
what is the boot seqance of cisco router
Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.
How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain
What is the distance limitation for 100BaseT? A. 305.955 ft B. 7283.46 inches C. 184 Meters D. 185 Kilometers
What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable
What is BGP Synchronization rules?? Can any one explain..???
Explain why UDP is lease favored when compared to TCP?
why we twist the cable in case of twisted pair cable?plz give me technical answer.
Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp
What is subnetting? Why is it used?
CCNA 
