What is a good device to use for obtaining viscosity data for a non-newtonian fluid?
No Answer is Posted For this Question
Be the First to Post Answer
A cylindrical vessel of 10m height has water upto 6m and is under a pressure of 15bar.What will be the pressure at the bottom most point of the vessel?
What factors go into designing the vapor space of kettle type reboiler?
Difference between Synthetic foaming agents V/S Protien based foaming agent?
In a screw compressor air is sucked from atm and mixes with the oil and is separated using separators.Will the viscosity of the oil get affected as moisture in air gets mixed with oil?
Explain some common piping materials used to transport slurries?
ACCOUNTING AND FINANCIAL ENGINEERING - EXAMPLE 34.17 : In the engineering calculations of interest rate caused by inflation, General Inflation Effect and Fisher Effect may be considered. Let I = inflation rate, R = nominal interest rate, r = real interest rate. According to Fisher Effect, (1 + R) = (1 + r) (1 + I). According to General Inflation Effect, r = R - I. (a) If I = 0.1 for all effects, both the values of R and r in the Fisher Effect are the same as R and r in the General Inflation Effect, find the values of R and r. (b) If R has the same value caused by both General Inflation Effect and Fisher Effect, find the possible values of R, r and I in term of R etc.
What is the pattern of interview questions and which field is of high importance viz., Mass Transfer, Heat Transfer, Petroleum Refining etc ?
2 Answers Cairn, IOCL, Reliance,
Question 106 - In a wavefunction, let P(x) = A cos kx + B sin kx. By using the boundary conditions of x = 0 and x = l, where P(0) = P(l) = 0, prove by mathematical calculation that P(x) = B sin (npx / l) where p = 22 / 7 approximately, n is a rounded number. A, B and k are constants.
What is vapour flooding and liquid floodin in distillation?
UNIT OPERATION - EXAMPLE 9.4 : Acetone and ethanol are separated using a distillation column with a partial condenser and partial reboiler. An equimolar, sub-cooled liquid feed enters at 100 kmol / hr and condenses 1 mole of vapor for every 6 moles of feed. The separation requires a distillate vapor that is 95 mol % acetone and bottoms liquid that is 5 mol % acetone. The reflux is returned from the condenser to the column as a saturated liquid and the operation is run at (L / V) = 1.4 * (L / V) min. Assume constant overflow conditions. (a) Feed operating line is y = [ q / (q - 1) ] x - z / (q - 1) where z = 0.5 for equimolar liquid mixture of 2 components, q = (L'- L) / F where L' = L + F + (F / 6) for condensation of 1 mole of vapor / 6 moles of feed. What is y = f(x)? (b) The rectifying operating line is y = (L / V) x + (D / V) (xd) where (L / V) min goes through the points A (0.95, 0.95) and B (0.53, 0.69), V = L + D. What is y = f(x)? Let xd = 0.95. (L / V) min is the slope of the 2 points A and B.
Question 99 - (a) The quantum number m is given by m = -s, -s + 1. If s = 0.5, find the values of m. (b) | T > = (cos T) | V > + (sin T) | H >. The V and H states form a basis for all polarizations. Let cos T = 0.8. (i) If (sin T)(sin T) + (cos T)(cos T) = 1, find the value of sin T. (ii) For | T > = a | V > + b | H >, where a x a represents the probability of | V > and b x b represents the probability of | H >. Which one is more abundant, | V > or | H >? (iii) Find the value of T without using any mathematical tools.
In Distillation Process heat transfer and mass tansfer will occur or not? alsowhere it will takes place?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)