What does following alloy designation indicate fg 250 ?
No Answer is Posted For this Question
Be the First to Post Answer
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
please send me jindal interview question if any one have?? my id is erabhishekparashar@gmail.com thnx in advance
what is difference between en8 and en24.if the usseage of motor shaft en8 what problems faceing?and what are the advantage of en24?
What is a Stirling engine?
hi please send the exam modle paper for mechanical engineering. Iam attending for vizag steel plant MT
can any one tell eligibility criteria (percentage of 10th,12th & b.tech) for IES & RRB ?
why condensate pump can be used instead of feed pump?
What are the defects in exhaust valve?
What are the requirements of a good fuel?
what will happen when petrol pour into diesel engine?
17 Answers APGenco, Hero Honda, Lupin,
Pink city of india
what is ERW PIPE & Seamless PIPE Out of ERW and Seamless which one gives good results for an impact force of 2700 N??
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)