Which feature should a routing protocol have to support vlsm?
- 0 Answers
- 690 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
Which two protocol tools use ICMP? (Choose two) A. ping B. telnet C. configure D. traceroute E. show commands F. standard access lists
What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable
Mention the ranges for the private IP?
Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual
Define the virtual path?
Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
Which type of switching reads just the address portion of the frame and then immediately starts forwarding it? A.) Cut-Through B.) Store-and-Forward C.) Tabling D.) Routing E.) Inverse ARP F.) Fast Forward
Identify the purpose of the Ping command? A.) Share routing information with a neighbor router B.) Transmit user data when buffers are full C.) Test connectivity at layer 3 D.) Test entire protocol stack
On an ISDN BRI interface, the control channel is the 'D' channel. What is the rate of this channel? A.) 64 Kbps B.) 1.544 Mbps C.) 128 Kbps D.) 2.048 Mbps E.) 16 Kbps
Which protocol can do load balancing on unequal cost also?
thnx jitender...its me shridh...m working for SG ltd..the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected?? plz tel me jitender how to resolve ths problem? as u sd loop in switch is the primary cause of ths....i wanna know how to resolve it...thnx for ur replys jitender sinha.
CCNA 
