The Datalink Layer is broken down into 2 layers, LLC and
MAC. The

LLC establishes media independence and what else?

A.) Provides Windowing.

B.) Provides flow control.

C.) Provides SAP's (Service Access Points).

D.) The Datalink layer does not have sublayers.

E.) Provides SAP's (Service Advertising Protocol).

F.) RIP Updates.

Answers were Sorted based on User's Feedback



The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independ..

Answer / guest

Answer: B C

OSI layer-2 SAP allows the upper layers to encapsulate
multiple layer 3

protocols.

IPX SAP is a protocol used to advertise NetWare services
every 60 seconds.

Is This Answer Correct ?    2 Yes 1 No

The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independ..

Answer / raja ganesh

b
bcoz it conrols the fast sender and slow receiver.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More CCNA Interview Questions

routing information

1 Answers   Wipro,


When configuring the subnet mask for an IP address, which formats can be used?A. dotted-decimal. B. Hexadecimal C. Bit-count D. Octal E. Binary

1 Answers  


Assuming no subnetting, which two pieces of information can be derived from the IP address 144.132.25.10? (Choose two) A. It is a Class C address B. It is a Class B address C. The network address is 144.0.0.0 D. The network address is 144.132.25.0 E. The host spoon of the address is 25.10

2 Answers  


Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers   Karrox,


Can you describe the Authentication Header (AH) Protocol?

0 Answers   CCIE,






What are 10base5 ethernet lans?

0 Answers  


How would you set the clock rate to 64K, on interface serial 0, from the interface configuration mode? A.) clock rate 64000 B.) bandwidth 64 C.) clock 64 D.) rate 64 E.) clock rate 64k F.) clock rate 64

1 Answers  


You want to set the console password to ralph. What would be the first command you need to execute from global configuration mode? A.) line console 0 B.) enable password ralph C.) login password ralph D.) set password= ralph E.) password ralph F.) login Ralph

1 Answers  


Can Anybody tell me if I wanna block all MP3,video sites from cisco 2600 router,how shall i proceed with ACL's?? Please post the steps for the following alonge with detail. Thanks to you all ..appriciated

5 Answers   Cisco,


How many valid ip will b in /21 in route summarization?

0 Answers  


Can anyone explain the STP Security features. Just like BPDU guard, Root Guard. Hi JITENDERA, i m specially looking for u?????

2 Answers  


What does the trace response !H mean? * A: Network unreachable * B: Not forwarded due to ACL restriction * C: Protocol unreachable * D: Port could not be reached

2 Answers  


Categories