What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot

2 Answers  

---

Which OSI layer end to end communication, segmentation and re-assembly? A.) Network B.) Transport C.) Physical D.) Application E.) Data-Link F.) Presentation

3 Answers  

---

What is the igp (interior gateway protocol)?

0 Answers  

---

What is a characteristic of Store and Forward switches? A.) They work at wire speed. B.) They are the same as Cut-Through switching in 'prune' mode. C.) They forward based on transport layer info. D.) They forward the frame before it is completely read. E.) They increase latency.

1 Answers  

---

Suppose we are having two router i.e. Router1 and Router 2 connected with each other on Serial Link,Router Network having ip 192.168.1.0/24. 1> which ip is used at router1 and router2 interface? 2>Which Command is used to assign ip to router1 and router2 interface?

1 Answers  

---

Why Operating System Have only 65,535 port Numbers

5 Answers  

---

What is raid in ccna?

0 Answers  

---

What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward

1 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

1 Answers  

---

How do we do encryption and authentication in L2F?

0 Answers   CCIE,

---

Which of the following are ways to provide login access to a router? A.) HTTP B.) Console C.) Telnet D.) Aux Port E.) SNMP F.) LLC

3 Answers  

---

Why do we have a Layered Model? 1) It reduces complexity 2) Allows for a standardized interface 3) Facilitates modular engineering 4) Ensures interoperable technology 5) Accelerates evolution 6) Simplifies teaching and learning

1 Answers  

---