How do you find valid hosts in a subnet?
No Answer is Posted For this Question
Be the First to Post Answer
Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp
Utilizing RIP, what is the limit when it comes to the number of hops?
In how many ways you can access the router?
The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'
You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet
How signalling can be explained in D channel of ISDN?
Identify the purpose of ICMP? A.) Avoiding routing loops B.) Send error and control messages C.) Transporting routing updates D.) Collision detection
What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a
The "ipx delay number" command will allow an administrator to change the default settings. What are the default settings? A. For LAN interfaces, one tick; for WAN interfaces, six ticks B. For LAN interfaces, six ticks; for WAN interfaces, one tick C. For LAN interfaces, zero ticks; for WAN interfaces, five ticks D. For LAN interfaces, five ticks; for WAN interfaces, zero Ticks
Which two statements about frame tagging are true? (Choose two) A. A filtering table is developed for each switch. B. Frame tagging assigns a unique user defined ID to each frame. C. A unique identifier is placed in the header of each frame as it is forwarded between switches. D. Frame tagging is a technique that examines particular information about each frame based on user defined offsets.
What is the Function of Layer3 Switch?
how many vlan can be configured on a single switch