Answer / parshant jaswal

In DC default gateway ip should be configure ip address of router’s interface ip address.
And at router default gateway ip is WAN interface ip address.

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

4 Answers  

---

Which information must a router know in order to perform proper and pungent routing? A. destination application of an incoming packet B. number of other packets in a single flow of data C. destination network address of an incoming packet D. number of routers that also know a path to the destination

1 Answers  

---

What must be true for two Routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D)Configured for PPP

3 Answers   Allied Group,

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers  

---

Identify the 3 kinds of routes IGRP advertises? A.) Interior B.) Dynamic C.) System D.) Exterior

1 Answers  

---

When ip confliction accord in subnet which ip assigned automatically and what it called?

0 Answers  

---

IGRP uses flash updates, poison reverse updates, holddown times, and split horizon. How often does it broadcast its routing table updates? A. 90 seconds B. 10 seconds C. 30 seconds D. 45 seconds

1 Answers  

---

If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2

1 Answers  

---

what is the need og jitu(config)#ip helper address <ip address> can any one exaplain it briefly specially shain i am looking towards you.Becoz you are the only one who can solve my that problem not even jitendera sinha

4 Answers  

---

Which of the following are examples of the Session Layer? A.) IP B.) Netbios Names C.) NFS D.) Token Ring E.) SQL F.) TCP

2 Answers  

---

Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface

2 Answers   Wipro,

---

Which IP Address Class can have 16 million subnets but support 254 hosts? A. Class C B. Class A C. Class B D. Class D

3 Answers  

---