Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of Clapper box in a shaper?
- 11 Answers
- 56770 Views
- HAL, Seven Rings Cement, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / suryamack
It facilitates the tool free from cutting in return stroke.
| Is This Answer Correct ? | 81 Yes | 13 No |
Answer / amit k. singh
Clapper box of a shaper is hinged at its side allowing
swing in only one direction from normal and it swings while
ram is in return stroke and avoids tool from rubbing
against the work and protects both.
| Is This Answer Correct ? | 60 Yes | 4 No |
Answer / dilip
It facilitates the tool free from cutting in return stroke.
| Is This Answer Correct ? | 46 Yes | 6 No |
Answer / shekhar
It facilitates the tool free from cutting in return stroke.
| Is This Answer Correct ? | 35 Yes | 8 No |
Answer / anand`
it protects the cutting tool 4m damage while return stroke.
As a result the work piece is also protected 4m damage.and
surface finish would be better.
| Is This Answer Correct ? | 20 Yes | 6 No |
Answer / soudipta
its facilitates the tool from not cutting the workpiece in
its return stroke and also saves the cutter tool from
getting damaged.
| Is This Answer Correct ? | 13 Yes | 3 No |
Answer / anoop maheshwari
It facilitates the tool free from cutting in return stroke.
| Is This Answer Correct ? | 11 Yes | 5 No |
Answer / karthick
it is used to avoid cutting the workpiece in the return
stroke
| Is This Answer Correct ? | 9 Yes | 6 No |
Answer / e.sivababu
mainly it is used for to swing cutting tool to retturn
stroke
| Is This Answer Correct ? | 7 Yes | 4 No |
Answer / s.mohamed faisal
TO SAFEGAURD THE TOOL FROM IDLE STROKE i.e RETURN STROKE.
| Is This Answer Correct ? | 5 Yes | 4 No |
Zimbobwe was formerly known as
why does cycle rim dont bend even in heavy loads???????
What is difference between cast iron and grey cast iron.
What are to be checked in an induction motor?
what is mean ovality?, how it is measured?
What are the differences between heat transfer and mass transfer?
where manning formula used
What is the difference between manufacturing and production?
What motivates you to do a good job?
What is base design drawings?
as started in the job offer notification, is our basic salary of 1lakh good for you if employed?
What is the function of "Speed Governor" in steam turbine? How it works?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
