Explain the difference between arp and rarp?

0 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

what is leased line and if any issue occur what will u do thai is trouble shootin occurs let leased line is down

1 Answers   Aptron, Cisco, HCL, Volvo,

---

Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in

1 Answers  

---

What is NOT a characteristic of a network segment on a switch? A. The segment has its own collision domain B. The segment can translate from one media to a different media C. All devices in the segment are part of the same broadcast domain D. One device per segment can concurrently send frames to the switch.

2 Answers   jetking,

---

Wild card mask always in odd value or even?

0 Answers  

---

Which OSI layer performs code conversion, code formatting and encryption? A.) Physical B.) Data-Link C.) Application D.) Transport E.) Presentation F.) Network

1 Answers  

---

Station A is transmitting data to station B, and expects an acknowledgment after every 400 bytes. After transmitting data for a while, the two stations determine the line is reliable and change to expecting and acknowledgement every 600 bytes. This is an example of (pick the best answer only): A.) BECN B.) Sliding Windows C.) Poison Reverse D.) Countdown timers E.) Split Horizon F.) Count to infinity

1 Answers  

---

What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3

1 Answers  

---

Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual

1 Answers  

---

Your company has been assigned the IP address of 201.222.5.0 and require having 20 subnets. As the company’s network administrator, find the following: a) the subnet mask (2 marks) b) the number of useable subnets (2 marks) c) the subnetwork address for the 4th subnet (2 marks) d) the first usable IP address for the 4th subnet (2 marks) e) the last usable IP address for the 4th subnet (2 marks) f) the broadcast address for the 4th subnet. (2 marks)

0 Answers  

---

Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a

1 Answers  

---