When you use the Cisco IOS command show configuration on a
router which part of the output shows the specific conferred
IP addresses and shored masks?

A. the IP host table

B. the interfaces output

C. each section of the output

D. the global configuration statements

E. the section under the autonomous system number



When you use the Cisco IOS command show configuration on a router which part of the output shows th..

Answer / guest

Answer: B

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More CCNA Interview Questions

What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace

2 Answers  


Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)#router igrp 100 Router(config-router)#network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0

3 Answers  


Which reserve port number talent use?

0 Answers  


Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

4 Answers  


If a router uses dynamic routing, how does it learn the route to remote networks? The router uses a DHCP request to obtain remote network numbers. The router uses a routing protocol to exchange routing info. with other routers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.

1 Answers  


Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 Answers  


In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to NVRAM before becoming enabled

1 Answers  


Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, that network is advertised with an infinite metric

1 Answers  


When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

1 Answers  


1350 Value in which type of access-list?

0 Answers  


What is difference between IPv4 & IPv6??

7 Answers   Hathway,


IP extended access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) all of the above C.) protocol D.) source address E.) port

3 Answers  


Categories