What is the basic difference between honing and boring.
No Answer is Posted For this Question
Be the First to Post Answer
So as to save petrol, can we replace some amount of petrol with LPG while injecting both LPG and petrol into a Petrol engine simultaneously (i.e., at the same time)???
What is Kirchhoff's Law ?
Explain the reason that why the tyres are always black in colour. Is this phenomena related to the heat conduction?
What is an injector pressure in heavy vehicles? Why it is used?
Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!
What are sliding contact bearings?
What is the difference between SPC & SQC?
Why the plastic materials used in the screwdriver's handles?
The coefficient of friction for the Asbestos-based materials used for clutch facing is a) 0.07 b) 0.17 c) 0.27 d) 0.37
1 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is the composition of Cast Iron Grade:GG P70 ?
Tell me the formula of heat loss in a pipe.
Why do you want to change your present company??
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)