The crown wheel of the final drive is connected to
a) Cage
b) Spider
c) Cross pin
d) Axle half shaft
No Answer is Posted For this Question
Be the First to Post Answer
What are Green Field Projects?
What is octane number and cetane number?
In a tractor, how the hydrostatic propulsion systems work?
Is it mandatory to maintain RG Part 1 & 2 manually? Can we submit excel format of the same to excise dept?
What is the fundamental equation for correct steering?
i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam
what is the three method of heat transfer?give example of each.
How can you measure bhp?
If two shafts used for transfer of drive are inclined to each other, then a) Slip joint is used b) Flange coupling is used c) Universal joint is used d) None of the above
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is reciprocating air compressors.
What is clutch drag?
So as to save petrol, can we replace some amount of petrol with LPG while injecting both LPG and petrol into a Petrol engine simultaneously (i.e., at the same time)???
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)