a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circ

a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose
highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in
kA. (Note: Covert 3-phase power in terms of kA to find answer.)

b)Using the below, determine the required minimum making
capacity in kA as a “peak value”.

Rate breaking capacity (Icn) ka:
Icn<= 1.5 Factor = 1.41
1.5

Question Posted / kf

0 Answers
1652 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

sir What is the different bet'n "Active & passive" sensors

3 Answers Kirloskar,

as a electrical student why should i hire you?

0 Answers TCS,

What is the difference between neutral and ground?

3 Answers Cethar Limited, Torrent Power,

what will happen if field winding of Synchronous generators given ac supply

4 Answers

we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.

0 Answers

How to reverse the direction of a DC motor ? By reversing the Armature wires or by reversing the field wires

2 Answers KFC,

How one can check the MAIN of a house wiring ?

0 Answers

what is the operation of Control Module(CM),MONITOR Module(MM), MONITOR Module DUAL (MM2),Signal Module(SM),Isolator Module(IM), please some one reply me.. the operation and application of these in FIRE ALARM SYSTEMS...

1 Answers

before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water

0 Answers

why always out of the 3 phase(RYB) of supply, in Y phase w.r.t the voltage is higher? on R & B phase the voltage will be lower as compared to Y phase?

1 Answers

why reactor is connected before capacitor in APFC panel

2 Answers

In a closed circuit if two 5volt power supplier are connected in parrel what is the current direction in tihs circuit?

1 Answers

For more Electrical Engineering Interview Questions Click Here