How to select the ratio of neutral ct? Is there any relation in between percentage impedance and neutral ct ratio ?
It should be equal to that of line CTs ,with same magnetic characteristics if you are employing REFR
| Is This Answer Correct ? | 1 Yes | 0 No |
how can i get elcctrical supervisor license & Certificate of competancy in gujarat? i have completed my B.E (Electrical) course from gujarat.
if a 3phase motor runnig in star delta starter with full load of its,and its rated 15 amps.now we conneted over load thermal relay at its main contactor,here what will be our amps sittings?
No load tap changing transformer working
An alternator is started without excitation then how much voltage it will produced at strating at full rpm??
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a campus site?
If we have 15000kw connected load in a factory than how much power demand sanction should be taken from electricity board. Pls provide complete calculation.
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
plz tell me,ht and lt panel terminals in substations explain beiefly
what are the different types and applications of compressors?
make control wire diagram of start and stop a function with a single push button
what is kVA
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)