Answer / vinodkumarkkp

To connect the resistance at the end of rotor ckt. winding

Answer / balajikamal84

connect the resistance at the end of rotor ckt or Slip Power Recovery System

Answer / rajneesh prasad patel

Slipring through connected resistance box rrs

what is the difference between LT and HT power supply?

26 Answers   Center One Mall, Central University, JSW, Siemens, Suzlon,

---

what happens if we connect two parallel ideal voltage sources across resistor?what is current flowing through resistor?

2 Answers  

---

How to calculate cable size for a particular load? i have 12 MW,11KV Motor 3 Phase, what should be cablesize? What are the points to remember for cable sizing calculations?

2 Answers  

---

During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?

0 Answers  

---

Less cost of delta connection over star connection a. No fourth neautral wire

1 Answers  

---

Do I need a special Transformer to put 240 VAC 3 phase into it and and get 480 VAC 3 phase out of it to run a machine? Or, do I just use an ordinary step down transformer and step up the voltage? Thanks

2 Answers  

---

I want to know the currect formula for industrial lighting lux caluculation & light fittings selection

2 Answers   MRF,

---

how you configure motorvision relay (L&T make)from DCS

0 Answers   Ispat,

---

we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.

0 Answers  

---

Interchange 7 and 6 ,÷and× 36×7+4-7×3

1 Answers  

---

I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??

0 Answers   Elmaco,

---

Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards

0 Answers  

---