Answer / fame

Yes

Answer / patelpankaj

yes

Answer / navanee251

yes

We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible

0 Answers  

---

Transformer diagram mention each parts ?

0 Answers  

---

What is acsr cable and where we use it?

0 Answers  

---

What is the use of lag compensator?

0 Answers  

---

what are the necessary basic electrical topics to learn for mechanical engineer to deal practical problems.

0 Answers   Honda,

---

Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?

0 Answers  

---

when the size of the cable used for the ht voltage is 300sqmm then what is the size of the conductor of each phase

2 Answers  

---

what is the use of CurrentTransformer in AVR ?

2 Answers  

---

Due to velocity saturation, MOSFET reaches saturation a.Before Pinch off b. After pinch off c. At Q point d. Before Q point e. After Q point

1 Answers  

---

at the time of starting back emf of a motor is zero.so how can it will start to run??

1 Answers  

---

The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?

0 Answers  

---

a 50hz motor to give 60hz whats happening in motor.what happen the motor.

6 Answers  

---