Answer / pavithra

Binding wire consumption 8kg per metric tonne of steel. Therefore 0.008kg(8g) per kg of steel

Answer / naveen s bhat

8kg per 1 ton.
8grms per kg.

Answer / naveen s bhat

8kg per metric ton

Answer / suresh sathanur

Quantity of binding wire required per ton or per kg ( or by % of reinforced steel is generally depends on many factors like spacing of steel bars ,Dia of steel bars and method of binding etc . But in normal construction generally the quantity of binding wire required will be in the range of 2 to 3% by weight of reinforce steel.

Answer / shuaib raza khan

1% of steel bars i.e. 10gm.

How to calculate the crank rod in slab

0 Answers   Bridge and Roof, Krishna Constructions,

---

rate analysis of shuttering

2 Answers  

---

As an engineer, what u should do when the construction of a building doesn't meet the required specifications?

9 Answers  

---

how much weighs a square feet of slab of 5 inches thick

2 Answers  

---

Two way slab, curtailment provided in both side in longside and short side. which side curtailment provided in one way slab?

1 Answers   IBA,

---

---

state the difference between direct and indirect cold water supply scheme

1 Answers  

---

What is the amount of work done by a carpenter, bar Bender and plaster Mason in interior and exterior plaster

0 Answers  

---

1) a)to prepare mortar for bricklaying how much amount of water should be added for its maximum strength and workability(to avoid cracks which results, when high quantity of water is added)?is their a formula or ratio? b) suppose we want to make 1:3 mortar,what is the best way to measure cement ,sand and water and how? c)time before which freshly prepared mortar should be used? d)proper way to mix and make mortar? e)when should curing start after laying bricks and for how long?and also how many hours per day? f)what is shear wall (please in terms of layman lol) bookish definisions are confusing.... g) and last,acc to codes what are max no. of course that should be laid in a day.

0 Answers  

---

why there is curve at the end in channel sectin

3 Answers   Birla, GNFC,

---

how many hacking to be made in one sqft for concrete surface before plastering as per the IS Code

17 Answers   L&T,

---

flow of fluid takes place viscosity compressibilityu surface tension deformation under shear force

0 Answers  

---

what is the minimum cement content for M20 & M25 as per is code -456(2000).

0 Answers   PBL,

---