do we use neutral grounding for resistive balanced load?
if we use what happen?
No Answer is Posted For this Question
Be the First to Post Answer
what is the difference between phase and neutral?
3 Answers IAF, Indian Airlines,
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
AIR GAP IS TERMED AS USEFUL. WHY?
State thevenintheorem?
our company have 750 kva oil transformer.still we have facing a problem that is when voltage is 11.5 kv coming from HT side then LT-side voltage is 420v or above at tape 1.please give me best solution to decrease the voltage.
If the supply voltage is same (say 440V) whether a system designed for 60 Hz frequency will work with 50 Hz frequency or not , if so pl. give clarification.
Whatis the procedure for getting Electrical (light) licence while Iam a diploma holder in electrical Engg . I Compleated my one yr Apprentice training & worked as a junior engineer (ele) for 2 yr(contract basis).
Why we are using Ohm's law? where it is applicable? explain.
10 Answers Pyramid Saimira, TCS,
what is phantom load, Give any example
why so maney smaller size capacitor use instead of single Big size capacitor in apfc panel
mounting of bucholz relay engle on transformer
374kvar capacitor bank connected across 600kw,6.6kv motor.what will happen if motor run at 50% , whether full kvar applied or half?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)