how the inner and outer body is separated in aircrafts?

0 Answers  

---

hi, could someone help me to find a control design for syncronising panel .

0 Answers  

---

I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.

0 Answers  

---

why we not use capcitor in Three phase motor ??

2 Answers   GOMS, Power Electronics,

---

when will cause the negative sequence falut in electrical system?

2 Answers   Schneider,

---

the winding of Gen and Motor is star or in delta ??? and why

1 Answers  

---

auto reclosing scheme for radial ehv feeder is to be implemented or not?

1 Answers   State Board,

---

A three phase load, around 4 km away from the 11/0.433KV distribution transformer (Neutral of Transformer is solidily earthed) and consisting of mainly very costly and sensitive electronic equipments is giving trouble due to high voltage difference between neutral and body earth. Whether this problem can addressed by connecting neutral at the load point solidly to earth?

3 Answers  

---

Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

---

what is the difference between elcb,rccb,mcb.

8 Answers   HCL, RCCB,

---

On PVC conduit the class "A" "B" or "C" is marked what does it shows. Either its thickness or its composition?

2 Answers  

---

What is IGBT?Where it is used? What is the difference between IGBT and Thyristor?

5 Answers   AC, Formo Plastic, HBL Power Systems, SECL,

---