Answer / nikhilkgsss

HIRA- Hazard Identification & Risk Analysis.
HAZOP-Hazard & Operability study.

The main difference lies in the name itself. HIRA represents a collective term which comprises of all the different activities involved in identifying hazards & evaluating risks at facilities to make certain that the risks to employees, equipments , public & environment are within the organization risk tolerance limit. Generally it consists of 3 main questions: Hazard, Consequences & Likelihood.

While HAZOP is a part of HIRA. It consists of what if analysis, check lists & failure mode & effective analysis.

Coal mill Instruments Equipments for cement plant And process diagram ?

0 Answers  

---

What is zone,loop/fire alarm system?

0 Answers   Emco,

---

To find closed tank level by DP transmitter , how to findout its range.and insomeplace they using range like - 1500 to +1500 mmwc why not 0 to 3000 mmwc. how they spilit they range for minus and plus.and why?

1 Answers   Kuwait Oil Company,

---

why pressure 3-15psi is used as industrial standard and what is the reason

2 Answers   JAL International, UltraTech,

---

why the discharge pressure of ID fan showing negative at fan running condition.(boiler operating condition.)

5 Answers  

---

䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ

0 Answers  

---

on which principle control valve works?

3 Answers   Lupin, Reliance,

---

yokogawa Temperature transmitter showing Error 15 which is Reverse Cal Fail (confirmation calculation result is bad) in manual they mentioned reasion That the output goes to the value set by hardware failure mode jumper. How can solve this problem ? anybody can say solution

1 Answers   GTL,

---

The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?

0 Answers   Process Control Technologies,

---

How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?

0 Answers  

---

Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.

1 Answers  

---

wht is mean by dpt(differential pressure transmitter)

1 Answers  

---