Can we get the outpot in c without using getch fiction? Answer is yes but outp

Can we get the outpot in c without using getch fiction? Answer is yes but output will stay on display 4 only few second.... But can we get output without using getch and also output will hold on the display...?

Question Posted / xyz

1 Answers
2687 Views
I also Faced
E-Mail Answers

Can we get the outpot in c without using getch fiction? Answer is yes but output will stay on disp..

Answer / krishnakamesh

GETCH is used for "answer is waited upto you need"

yes it was possible , when you are using DEV C++ software,it wont ask getch function.

but you are using normal TURBO C++
there was an option need not use use GETCH.

that is press ALT+F5 in keyboard then answer paused

thatswhy we avoid this complexity, we use GETCH in c programmed ending

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

wt is cold junction compensation

1 Answers

why full bore ball valve is not used in steam applications?

1 Answers

how can we calibate ph meter. how can we calibrat conductivimeter how can we calibrat massflowmeter & it s working.

1 Answers

Is an analogue only transmitter as accurate as a smart transmitter?

2 Answers SCA,

why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.

0 Answers ONGC,

If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used? Please tell me its Calculation formula.

5 Answers MOL,

what is start up vent valve ? why it is used in boiler?

8 Answers ACC, Bhushan Power Steel,

What is the relation between electronics & instrumentation

2 Answers

Please explain the difference between instrument range and calibration range in terms of pressure transmitter? line design pressure: 93 bar operating pressure : 82 bar press Transmitter Range? calibration range ?

3 Answers L&T,

i install a DP transmitter of Faugi on drum level of boiler but i face a problem in it when i engergize the transmitter the meter shows 0 or 100% no variation in it.the distance of two points is 19.5 inches, i am in trouble please suggest me what can i do it's very urgent Please reply me as soon as possible Best regards ikraam haider

5 Answers

how to check control valve was passing?how to check online?

3 Answers

What is meant by calibration

5 Answers

For more Instrumentation Interview Questions Click Here