Describe kW and kva and difference between
Answers were Sorted based on User's Feedback
Answer / bajiya1995pankaj@gmail.co
Kw is rating of power and kva is rating of transformer
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / sourabh vishwakarma
w=va
kw=kva
but differnce is only of power factor if consider unity pf than kw=kva
kw=v*a*pf*1000
kva=v*a*1000
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / makku
kw is the active power whereas kva is reactive power.in all m/cs generally active power is consumed and reactive power is not considered in household light bill
| Is This Answer Correct ? | 6 Yes | 7 No |
Answer / nidhi sheth
Both are power units. Voltage multiplied by current.
The difference is normally KVA has a power factor following it i.e., it is used in Ac measurements.
KW = Kilo volt * Current
KVA = Kilovolt * Current * power factor
When power factor =1, then KVA = KW
| Is This Answer Correct ? | 0 Yes | 2 No |
why are we adopting 132kv,220kv for transmission rather than using 440kv at all transmission lines as it gives lower losses?
Is the theorem applicable to ac sources?
what is harmonics?
what is V0/V rating of cable
Why we didn’t feel electric shock in an electric train ??
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
Why is the generator rating always in kVA and motor rating in kW?
How to Convert horsepower to kva? what is the three phase formula? explain me if u can Example..i have 50Hp Moter how can i convert in kva tell me formula three phases Rehan Smileavail@msn.com
What are the different protection systems takes place on control panel board?
I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???
What is the function of RCCB? What are the different sensitivity ratings & each application?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)