Reason of secondary of ct always short

Categories >> Engineering >> Electrical Engineering
Suggest New Category

Question Posted / dinesh

5 Answers
6376 Views
ANITS, EID Parry, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Reason of secondary of ct always short..

Answer / kondi suresh

to avoid the saturation of transformer core.

Is This Answer Correct ?

4 Yes

1 No

Reason of secondary of ct always short..

Answer / bhishma narayan thakur

For protection of CT from flash over in secondary

Is This Answer Correct ?

1 Yes

1 No

Reason of secondary of ct always short..

Answer / pascal

To Aviod Saturation Of secondary core which could expolde

Is This Answer Correct ?

1 Yes

1 No

Reason of secondary of ct always short..

Answer / m tashfeen abbasi

it protected the ct for corona effect

Is This Answer Correct ?

0 Yes

0 No

Reason of secondary of ct always short..

Answer / shafeeq babu

current transformer is step up transformer, so the secondary voltage is dangerous due to current passing trough the conductor. so the CT secondary side is short ckted

Is This Answer Correct ?

4 Yes

5 No

Post New Answer

More Electrical Engineering Interview Questions

Why fuel tanks to be earthed ?

6 Answers Electronics, Hindustan Petroleum, HPCL, Ispat,

How much earthing frequency is capable?

0 Answers

How many types of lightings are there

2 Answers ABB, Met Trade,

This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.

0 Answers

We have two Al.busbars each of size 125mm*10 mm connected in parallel.To increase the current rating ,can we connect third busbar of size 100mm*10mm in parallel to existing two busbars?In my opinion ,if we connect busbars of different sizes in parallel,then the busbar of lowest size will take much current.So this type of paralleling should be avoided .Am I correct?

1 Answers PDP Steel,

Why selected cable colour red yellow and blue in 3 phase Electrical system?

9 Answers Crompton Greaves, Essar, Gridco,

how many desk top computer can connect to a 25kva 3phase generator?

1 Answers

Why Magnetic Core Balance test is performed only on Star side of Transformer and not on Delta Side of Transformer (Vector Group Dyn11)?

1 Answers

To test Transformer we give HT side 440V to see wheather that it is producing 17.6V on LT to verify Voltage ratio is correct or not but when we give the 440V voltage to LT side then what will happen to HT voltage ?

3 Answers Aditya Birla,

how the magnetic flux is said to be rotating & alternating?

4 Answers

what is the difference between multimeter and megger?

3 Answers Bhel, Metro,

What is the Nyquist criterion regarding control systems?

0 Answers GE,

For more Electrical Engineering Interview Questions Click Here