We have a Yokogawa Micro-XL DCS, which is having around 300 I/O, but whenever there is any wire gets grounded in field, the 24v supply to all loops gets dipped & all the indications at DCS goes to IOP(shows input open), at present we have fixed 500mA fuses in all the lines but which does not working. Does it required to replace with lower amps fuse, then how much or is there any other solution for this.

2 Answers  

---

why most of the DP transmitters using maximum range as 0-2500mmwc?why not 1000 2000 3000 4000mmwc

2 Answers   SPIC, TNPL,

---

Can we use twisted pair cable instead of ethernet for communication?

1 Answers   Yokogawa,

---

What is the differace between Volumatric flow meter and Mass flow meter.

4 Answers   Reliance,

---

how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?

0 Answers  

---

what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?

0 Answers  

---

difference between DCS @ SCADA system? and how can use in field

5 Answers   Marafiq,

---

What is the meaning of Dry contact and Wet Contact related to to sensors?

5 Answers   Emerson, Google,

---

Conversions

0 Answers   CCIE, Nestle,

---

How to work DCS? how to get the signal from Field Instruemtns to PIB to Console?

2 Answers   Alstom, Invensys,

---

How to calculate the flow rate in Vortex flow meter?What is K factor?Can you give me an example calculation to understand the same as better?

1 Answers   npcc, Zadco,

---

how to commission furnace ( water heater)

0 Answers   Petrofac,

---