Answer / inst

DP switch have two ports that is high and low..Example : Our s.p is 50 psi...Forfor this we have to apply pressure to high port  at the same time lp port should be open to atmosphere..When pressure reached 50 psi switch contact will be changed..

Answer / rahul

For DP switch calibration first apply zero pressure to low side and gradually increase high side pressure upto dp range. (0 to high) then increase low side pressure upto pressure previously applied on high side ( high to 0). then again increase high side pressure upto dp range (0 to high). then increse low side pressure upto equilizing with high side pressure ( high to 0) . this process will go more than 5 scale to have more accuracy upto maximum operating line pressure.

what is hot loop check and cold loop check.

3 Answers   Bapco Bahrain Petroleum Company,

---

Condensation within a sight glass? Would you expect there to be more problems when using a sight glass if there is condensation on the inside or the outside of the glass, and why?

1 Answers  

---

how to calibrate an error for pressure transmitter, make it easy to understand

2 Answers   Descon,

---

can u briefly explain aboutan aryton shunt multirange DC ammeter?

0 Answers  

---

Why the Proximitor supply should be Negative voltage? Why should not we give Positive voltage to the Transducer?

6 Answers   Moser Baer,

---

What are different types of valves?

0 Answers  

---

if found error in magnetic flow meter?how can we adjust?

2 Answers   ANI Instruments, Techint,

---

i/p converter always for supply pessure from 3~15 psi only !! And from where this converter bleed the air.

2 Answers  

---

diff c and c++

1 Answers  

---

Ohm’s law, kirchoff’s law, pascal’s law, Bernoulli’s therem,

1 Answers   CCIE, Emcure,

---

how to control pid

0 Answers  

---

What is the differerence between hysterisis and linearity.

0 Answers   CCIE,

---