How can calculat the lode of transformer?

Question Posted / guest

2 Answers
6733 Views
Maruti Suzuki, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How can calculat the lode of transformer?..

Answer / jaspreet singh

load of the t/F calluclated by Formulla under root
3*volt*currenty*Power factor

Is This Answer Correct ?

10 Yes

0 No

How can calculat the lode of transformer?..

Answer / sheikh

there is a simple way, transformer rating denoted in KVA
A clamp meter may be used to measure the current of
transformer.

Is This Answer Correct ?

7 Yes

5 No

Post New Answer

More Electrical Engineering Interview Questions

we want to feed 3 phase supply to 70 ton AC load.what will be the size of (3 phase)cable require.

2 Answers BSES,

My energy meter ratio is -/110/root 3,1A and connected line CT is 100/1,PT is 11kv/110 so what is the MF for meter

1 Answers Apollo,

In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?

0 Answers

what is on line transformer and off line transformer.

3 Answers Cisco, HP, ICC,

what is VFD and where is use of it

5 Answers

what is DG synchronization panel plz explain the working!!!!!!!

12 Answers Kirloskar, Lanco, MPS Techologies, Sedemac,

WHAT IS OLTC OF TRANSFORMER? WHERE IS ITS USED EITHER ON PRIMARY OR SECONDARY SIDE OF TRANSFORMER?

2 Answers

What is called limb of a transformer?

0 Answers

What are the test performed on A faulty transformer ?

2 Answers Bhel,

A 3 phase motor, 440 voltage, induction motor. If we take out rotor from motor and if we give supply 440 volt to stator then what happens?????

20 Answers

When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<

0 Answers Lupin,

how can we know the size of cable cross-section from current rating ?

3 Answers

For more Electrical Engineering Interview Questions Click Here