Answer / krishnakamesh @ j.e.

sdv means shutdown valve
bdv means blow down valve
Both are used in ESD (emergency shutdown) condition.

SDV: ( closed valve)
it was used in plant inlet & outlet places.whenever plant
was partially OR total shutdown condition, at that time
plant was not disturbed from/to another process,closed the
disturbed process through SDV".

BDV : (opened valve)
It was used in sudden flare OR pressurized
condition,relief that pressure( to avoid dangerous
condition) used this valve.

Both are operated with solenoid valve, with electrical supply.

any thing want more refer google

Where can i take training in intools software for Instrumentation design??

9 Answers  

---

what is principal of pressure transmitter?

5 Answers   Hindalco, SPB,

---

What is difference between sensors and transducers?

2 Answers  

---

What is mean by Ethernet, Device net and Control net? For what application we are using these?

4 Answers  

---

I work on a electronic positioner transmitter 4211 at the field.I connect my multimeter in series to get the current output then I calibrate it to 4ma in 0% of position of the valve and 20ma in 100% position of the valve.My problem is in the field I get the correct output current based on my multimeter but in the dcs they only receive 40% in a output 20ma of this positioner.Then I try to simulate in this analog card and they receive the equivalent percent on the value that I simulated.Is ther any possibility to reset the zero and span of this positioner 4211 fisher.And what other possibility I can do to fixed this.This is my email add ( landicho_randy@yahoo.com )

4 Answers  

---

Explain plc level and its type?

0 Answers  

---

what is stability

2 Answers   IOCL,

---

HOW THE ORIFICE & PRV SIZING BE HAPPENED -- EXPLAIN IN BRIEF

3 Answers  

---

what is the difference between signal cable and ontrol cable?

14 Answers   Essar,

---

I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?

0 Answers  

---

what is the difference between SCADA and DCS?

5 Answers   ACC,

---

how to calibrate 0- 150 psi presure gauge by dead weght tester

0 Answers  

---